G-3 Range Management - Training on Quantico

 Equipment emplacement/retrieval 

System maintenance/repair 

System operation 

Training Design

Exercise Design

Training event scheduling and coordination support

Aligning and incorporating Training and Readiness (T&R) Standards 

Performance Evaluation Checklist development                

After Action Review Support

The Moving Infantry Target is comprised of a single target-lifter mounted to a wireless remote controlled, self-powered mover. When the target board is hit by a round, the hit sensor will register the impact and the MIT will react as prescribed in the preset control system. Different commands, modes and speeds can be selected and transferred to the MIT, either manually from the controller or as commanded in an advanced scenario. This creates an almost endless number of possible MIT training alternatives.

The MIT can be configured as a fixed installation or deployable unit to enable training in urban environments, as well as on traditional firing ranges. A wide variety of accessories are available for the lifter, such as thermal signatures, armor protection, and an easy-to-use control system.

The Stationary Infantry Target Mechanism is a multi-purpose target mechanism designed to expose and conceal a human size target to an individual or unit conducting live fire. The target holder has an integrated hit sensor. When the target board is hit by a round, the hit sensor will register the impact and the SIT will react as prescribed in the preset control system.

The target is ruggedized and provides high reliability in every kind of environment, from arctic winter to tropical heat. It also features easy installation, simple maintenance and long life.

• Raise and lower on command 
• Drop when hit
• Drop when hit then raise automatically
• Cycle through raised and lowered positions 

• 25 portable targets available
• Primarily used for Sniper Training
• Battery powered and will cycle through approximately 1,800 down and up cycles before requiring a recharge
• After being hit, the target returns to the upright position and automatically shuts off until the silhouette is again hit and knocked down

The FireFly realistically creates the acoustical impression of a battlefield. The FireFly is designed to play pre-recorded sound files of more than 100 different sounds for more than one hour. Sound files can be stored and/or modified utilizing a standard computer equipped with a Compact Flash Card (CFC).  Similarly,  SES records and plays up to 254 sounds using 16-bit 44.1KHZ CD quality audio. Sound track play time of 30 minutes can be remotely triggered via the Range Control Station (RCS) or Hand Held Controller (HHC).